Optic Mount Plate for Ruger American 45 Compact Pistol

Description

Ruger American 45 Compact Optic Mounting Plate

*** Fits the Ruger American 45 Compact Pistol only. Will not fit Ruger American 9 Compact Pistols.***

We present to you the Optic Mount Plate for the American pistol. Made from aircraft grade aluminum and then hard anodized to mil spec for longevity and scratch resistance, this is the optic mount that you need to bring your American to the next level. This no gunsmithing required mounting plate is designed to replace your rear sight, no milling of the slide required.

Please refer to the lists below for the 80 Micro and Standard Optics approved for our Optic Plate. 

Get yours today!

Listing is for one Optic Mount Plate, two 6-32 x 5/16 Hex Flat Head Cap Screws, two 6-32 x 1/2 Hex Flat Head Cap Screws, and two 6-32 x 3/8 Hex Button Head Cap Screws. *** Optic NOT included ***

*** For the installation of your optic, Blue Locktite is required. Remove the pre-installed optic mounting screws from our plate before sliding the plate in the dovetail of your slide. This is a snug fitting plate and will need to be tapped in place using a hard rubber or nylon hammer. With Blue Loctite snug up the center set screw securing the plate to the slide. When installing the optic on the plate do NOT use the metric screws that came with your optic, we provide both Button Head Cap screws and Flat Head Cap screws in the correct thread size for our Optic Mount Plate to mount your optic to our plate. Again, Blue Loctite should be used to secure the our optic screws to our plate. Screw head type selection is determined by the type needed for your particular optic.  ***

Available in Black.

Fits the Ruger® American 45 Compact Pistol only. *** Does not fit American Full Size, American 9 Compact, American Competition model, LC9s, EC9s, LCP, or any other Ruger Pistol.***

As always, proudly made right here in the USA.