Optic Mount Plate for Ruger LCP MAX Pistols

Description

Ruger® LCP MAX® Optic Mounting Plate

Introducing the Optic Mount Plate for the LCP MAX pistol. Made from aircraft grade aluminum and then hard anodized to mil spec for longevity and scratch resistance. This is the optic mount that you need to bring your LCP MAX to the next level. No gunsmithing required mounting plate, designed to replace your rear sight with no milling of the slide required.

Please refer to the approved Optics List below for the 41 optics that fit our plate.

Get yours today!

Listing is for one Optic Mount Plate, (2) 6-32 x 5/16 Hex Flat Head Cap Screws, (2) 6-32 x 3/8 Hex Button Head Cap Screws,  and one 8/32 Set Screw. *** Optic NOT included ***

*** For the installation of your optic, Blue Locktite is required. Do not use the metric screws that came with your optic, we provide both Button Head Cap screws and Flat Head Cap screws in the correct thread size for our Optic Mount Plate to mount your optic to our plate. Screw head type selection is determined by the type needed for your particular optic. The 8/32 set screw is to be used to secure the Optic Plate to your slide. Holes for mounting the optic are tapped for 6/32 screws. ***

Now available in Red or Black.

Fits Ruger® LCP MAX® Pistols. *** The Optic Mount Plate does not have a cutout for the LCP MAX California Compliant LCI. ***

As always, proudly made right here in the USA.

Micro Optics

These Micro Optics are approved for use on our optic mount plates.

*** The Holosun 407k and 507k can vary in the location stud height due to the different production runs. The pegs are correct for the optics listed but there can be some differences in those optics from what we have found over the last year or so. Sanding the locating studs down is the option to allow them to fit in that case.***

We strive to make all parts we manufacture to be drop in, although there is the rare occasion where a part will HAVE to be fitted to the tolerances of your particular pistol. We cannot control the tolerances of mass produced firearms, therefore we highly suggest that if you run into a tolerance issue to contact us at [email protected] before taking it to a qualified armorer to fit the part. We also offer installation of all triggers, trigger kits, and parts that we make for a nominal fee.